|
Post by mirkosoft on Aug 27, 2017 22:28:26 GMT
So, I'm going to do IEC Serial Switcher. Miro
|
|
|
Post by ken b on Aug 28, 2017 15:28:21 GMT
I built a DB9 to serial kit for John Ferrell he has first hand knowledge of how it works, he would be a great person to ask on what it can do as for damaging equipment just make sure all your electric plugs are wired properly in your house ......just ask craftsman about blowing up his 128DCR and a CMD drive because he used 2 outlets and had a HUGE (BANG) ken.
|
|
|
Post by mirkosoft on Aug 28, 2017 15:44:58 GMT
I want to create switcher by this way:
IN: devices onnected normally to serial port OUT1: cable connected to DCR serial port OUT2: cable connected to DTV serial port
nothing more. I want to use DB9 switcher where I wire each DIN-6 pin to DB9 separately and wiring out to ouput will be same... Is it still dangerous? Miro
|
|
|
Post by ken b on Aug 28, 2017 16:04:22 GMT
the way you just explained it , is safe to do I do not know what you ordered for parts ....bare db9`s and bare 6 pin dins? , or cutting a pre made serial cable and soldering to a db9, or using a pre made db9 and soldering to a 6pin din but honestly none of that matters as all the above ways work what type of switch box are you planing on using ...the push button or the big turn knob I prefer the big turn knob as it switches all the lines I am not 100% sure how many lines the push button switch will switch just make sure all 3 cables are wired exactly the same when you are done ken.
|
|
|
Post by mirkosoft on Aug 28, 2017 16:17:11 GMT
Ok, I post pictures when finish. Miro
|
|